mod. 6012.1074/UK - 02/04
2
1
4
3
AS 80
REMOTE-CONTROL ALARM UNIT
OPERATING INSTRUCTIONS
1. REMOTE CONTROL
REMOTE CONTROL UNIT BATTERY LOW
The LED on the remote control flashes when a button is pressed.
When engaged, the alarm causes the direction indicators to flash 6 times quickly
instead of 3.
2. ARMING
The alarm unit engages only with the key contact off.
• Press button P2 of the remote control unit
This is confirmed by 3 flashes of the direction indicators and 3 audible chirps
(if on)
The doors lock and the LED comes on steady.
3 x 3 x
AUX output
DOOR UNLOCKING
OFF
DOOR LOCKING
ON
PANIC alarm
3. PROTECTION
After an initial neutral time of 40 seconds, the LED starts to flash and the sensors
are ready to determine all possible alarm causes.
POSSIBLE ALARM CAUSES
• Door - hood - trunk opening
•
Passenger compartment intrusion detected by modules connected to the alarm unit
• Ignition attempt
• Current absorption
4. ALARM SIGNAL
The triggering of an alarm generates an acoustic and optical alarm cycle lasting 30 sec.
The alarm cycle, for each of the possible causes, can be repeated for at most 8
consecutive times.
ALARM SIGNAL SWITCH-OFF
To interrupt an alarm cycle, press button P1 of the remote control. The alarm unit is
not disarmed.
5. DISARMING
• Press button P1 of the remote control
This is confirmed by 1 flash of the direction indicators and 1 audible chirp (if on)
The doors are unlocked, the LED goes off and the dome light comes on (if
programmed and connected).
30 sec 30 sec
ALARM
CYCLE
1 x 25 sec1 x
ALARM MEMORY
If, during the previous arming time, a cause of alarm has been found, when the alarm
unit is disarmed, two audible chirps will be heard and the LED will flash in a codified
sequence, indicating the cause of the alarm.
2 x
ALARM
MEMORY
6. ARMING WITH MODULE DISENGAGEMENT
To arm the alarm without engaging the connected electronic modules (power windows,
volumetric protection...) press the P2 button of the remote control for over 2 seconds.
Disengagement of the modules is indicated by 6 flashes of the direction indicators.
7. ARMING WITH SIREN DISENGAGEMENT
To arm the alarm without engaging the siren (optical alarm cycles only) press the P2
button of the remote control and, within 15 seconds, the P3 button.
Disengagement of the siren is confirmed by 3 additional audible chirps
SIREN
DISENGAGED
6 x
2 sec 6 x
DISENGAGED
MODULES
1 x = Current absorption
2 x
= Electronic modules
3 x
= Ignition attempt
4 x
= Door - hood - trunk opening
5 x
= Hood opening
6 x
= Radio module
8. TEMPORARY DISENGAGEMENT OF AUDIBLE CHIRPS
If these are switched on, the alarm unit emits audible chirps every time the alarm unit
is armed/disarmed. To temporarily disengage these signals, press button P3 from the
remote control before pressing P2 (on) or P1 (off).
Disengagement only refers to subsequent arming/disarming.
9. PANIC ALARM
By pressing buttons P1 and P2 of the remote control together, the alarm unit performs
an alarm cycle.
During installation, it is only possible to select the panic alarm with the unit on or off.
To interrupt the panic alarm, press button P1 on the remote control.
10. CAR LOCATOR
With the alarm engaged, by pressing button P2, the direction indicators and the dome
light come on for 25 seconds.
This function facilitates vehicle localisation.
11. STORED REMOTE CONTROLS CHECK
Every time the dashboard is switched off, the LED emits a number of flashes equivalent
to the number of remote controls stored in the unit. This permits checking that the
number of enabled remote controls corresponds to those in possession of the user.
30 sec 30 sec
25 sec25 sec
ALARM
ON
n x
n=number of enabled remote controls
12. VALET MODE
When valet mode is engaged, all the alarm functions are disengaged. The system
is configured as simple remote-controlled locking unit.
The VALET mode is indicated by continuous LED flashing, with dashboard on.
ENTERING VALET MODE
• Switch on the dashboard
• Press buttons P1 and P2 at the same time for at least 2 seconds.
The alarm unit gives 1 flash of the direction indicators and 1 audible chirp
With the dashboard off, the LED flashes continuously
VALET
MODE
1 x1 x2 sec
UK
To Next Page
Need help?
General