UP BUTTON
Short single presses toggle through
the three display modes: W.TMP =
Water Temperature, S.TMP = Set
Temperature, TIME = Clock.
Holding the button will force the
controller to begin adjusting the set
temperature and will raise the set
temperature point.
Also used for adjusting settings.
DOWN BUTTON
Short single presses toggle through the three
display modes: W.TMP = Water Temperature,
S.TMP = Set Temperature, TIME = Clock.
Holding the button will force the controller to
begin adjusting the set temperature and will
lower the set temperature point.
Also used for adjusting settings.
SANITISE BUTTON
Press once to activate a 20 minute
sanitisation and clean up cycle to
refresh water quality after spa use.
A second press will cancel the cycle
if already running.
WATER TEMP / TIME BUTTON
A shortcut key designed to quickly
toggle between actual water temp
and time display modes.
OK BUTTON
Used to confirm and save setting
adjustments or to enter setting
adjustment menus.
SLEEP TIMER
INDICATOR LED
This LED will turn on
when the controller is
in a sleep mode.
SANITISER INDICATOR LED
This LED will turn on to indicate
that the ozone or uv sanitiser
unit is operating (if fitted).
HEATER INDICATOR LED
This LED will turn on when the
heater or heat pump (if fitted)
is operating.
AUTOMATIC INDICATOR LED
This LED will turn on whenever
the filtration pump is in automatic
mode.
LIGHT BUTTON
Press to toggle spa
lights on / off. When
light is first turned
on the user has the
ability to adjust the
light effect mode or
colour via the up,
down & OK buttons.
BLOWER BUTTON
Press to toggle blower
on/off. A single press
turns blower on in
vari-speed mode. Use
up & down buttons to
vary speed. A double
press activates the
ramping mode.
PUMP B BUTTON
Used to toggle any
additional jet pump
on / off (if fitted).
PUMP A BUTTON
Used to toggle the
filtration pump
on / off / auto.
QUICK REFERENCE GUIDE
AM
PM
OFF
ON
°C
°F
MODE
SPD
BRT
SAT SUN MON TUE WED THU FRI
MENU ICONS
Sleep timer menu icon
Light menu icon
Blower menu icon
40.00
STATUS ICONS
Keypad locked
Sanitise cycle operating
OFF
ON
POWER SMART
Filtration cycle operating
Fault condition has occured
DISPLAY MODE ICONS
Water Temperature
Set Temperature
Clock
To Next Page
Need help?
General
