!
WARNINGS
Please read the following before installing or connecting this appliance
RISK OF ELECTRICAL SHOCK
SV Series Spa Controls
All electrical connections must be performed by a licensed electrician and
must confirm to all national, state and local electrical codes in effect at the
time of installation.
The appliance should be supplied through a residual current device (RCD)
having a rated residual operating current not exceeding 30mA.
The appliance must be connected to a suitable rated and weather protected
power supply. The supply line should be a dedicated power circuit and
means for disconnection must be incorporated in the fixed wiring in
accordance with your local wiring regulations. Means for disconnection from
the supply mains should have a contact separation in all poles that provide
full disconnection under over voltage Category III conditions.
Earthed appliances must be permanently connected to fixed wiring
(European models only).
The appliance contains no serviceable parts. Do not attempt service of this
control pack. Contact your dealer or authorized service agent for assistance.
Turn the mains power OFF before servicing appliance or modifying any cable
connection
Suitable for indoor use only or when installed under a weatherproof spa
skirt. The appliance should be installed in an enclosure such that all
electrical connections cannot be accessible to the user without the use of a
tool.
Low voltage or improper wiring may cause damage to this appliance. Read
and follow all wiring instructions when connecting to power supply.
Any damaged cable must be replaced immediately.
To prevent electric shock hazard and/or water damage to this appliance, all
unused receptacles must have a water proof seal in place.
Parts incorporating electrical components must be located or fixed so that
they cannot fall into the bath or spa.
Parts containing live parts, except parts supplied with safety extra-low
voltage not exceeding 12V must be inaccessible to a person in the bath or
spa.
This appliance must not be installed in proximity to highly flammable materials.
o
Water temperature in excess of 38 C may cause hyperthermia (heat stress).
It is the spa manufacturer's and/or installer's responsibility to select suitable
loads and configure load shed settings (if required) to ensure the system
does not exceed its rated maximum total load.
It is the installer's responsibility to ensure the floor is capable of supporting
the expected load of the bath or spa and an adequate drainage system has
to be provided to deal with overflow water.
A whirlpool spa should incorporate a water filtration system where the
required level of water purity can be achieved.
An adequate drainage system has to be provided if the equipment is to be
installed in a pit.
This appliance is not intended for use by persons (including children) with
reduced physical, sensory or mental capabilities, or lack of experience and
knowledge, unless they have been given supervision or instruction
concerning use of the appliance by a person responsible for their safety.
Children should be supervised to ensure that they do not play with the
appliance.
1
To Next Page
Loading...
Need help?
General
