Now, with the headers installed, you can easily drop the ESP32 Thing
board into place on top of them.
Go ahead and solder all the pins to the ESP32 Thing at this time.
If you're new to soldering, check out our through-hole soldering
tutorial. We'll wait here.
If you’re new to soldering, you may want to solder just the first and last
position on each side, then pull the board free of the breadboard, to avoid
heat damage to your breadboard. You may find it easier to remove the
board from the breadboard by inserting a flat-edge screwdriver under the
end of the ESP32 and gently levering the board away from the breadboard
by turning the handle of the screwdriver.
Install the Female Headers
Page 10 of 20
To Next Page
Loading...