Hardware Hookup
Header pins were left off the Qwiic Pro Micro to allow users the flexibility of connecting any type of 0.1" header to
the board. For temporary connections to the I/O pins, you could use IC hooks to test out the pins. However, you'll
need to solder headers or wires of your choice to the board for a secure connection. For advanced users, you
could also design a PCB to take advantage of the castellated edges for a lower profile. Here are a few tutorials to
connect to the pads depending on your personal preference.
How to Solder: Through-Hole Soldering
SEPTEMBER 19, 2013
This tutorial covers everything you need to know about through-hole soldering.
To Next Page
Loading...