Tip: You could also use the SparkX BlackBoard. It's basically a RedBoard with additional features. This
would reduce the amount of components and time soldering headers to the board. Keep in mind that
SparkX products are rapidly produced to bring you the most cutting edge technology as it becomes
available. SparkX products are tested but come with no guarantees. Live technical support is not available
for SparkX products.
You will also need a Qwiic cable to connect the shield to your Twist, choose a length that suits your needs. The
Qwiic to breadboard cable is good if you want to easily plug the Qwiic Twist into a 3.3V platform such as Teensy.
SparkFun BlackBoard
SPX-14669
Qwiic Cable - 100mm
PRT-14427
Qwiic Cable - Breadboard Jumper (4-pin)
PRT-14425
To Next Page
Loading...
Need help?
General