SPARKLETTS Pure Water Dispenser 500 Series User Manual

4. Remove cup holders, if applicable.
Open the cooler lid using the key
provided in the replacement kit (Fig 4).
5. Close cooler door. Place a glass or other
container below the water faucets to
catch any drips.
Fig 2
Fig 5Fig 4
Fig 3
Fig 6
Fig 1
Your water dispenser exterior should be thoroughly cleaned every 6 months, and your
SmartFlo™ water cartridge replaced every 12 months. If you do not have a replacement cartridge
handy, you can order one here and it will be shipped directly to you. Your replacement kit will
include a SmartFlo™ cartridge, bottle adaptor, lid key and plug for the bottle tube:
Before you start cleaning, wash your hands thoroughly with soap and water for at least 20 seconds.
TIP: Have a bucket nearby to
dispose of the used SmartFlo
™
cartridge and bottle tube,
which will contain water.
DIY: HOW TO CLEAN
YOUR WATER DISPENSER
TM
TIP: The best time to replace your water cartridge is when the existing water bottle is empty.
WHAT YOU’LL NEED:
• SmartFlo™ replacement cartridge
• 70% rubbing alcohol or disinfecting wipes
• Clean cloth or soft brush
• Rubber gloves
• Bucket
• Towels to absorb any water spills
1. Turn o the hot tank heater switch
on the back of the dispenser and
unplug your unit (Fig 1). Let the unit
stand for one hour before cleaning
to allow the hot tank to cool.
2. Slide the cooler door up and
remove the empty water bottle
(Fig 2). Wipe interior cabinet
with 70% rubbing alcohol or
disinfecting wipes.
3. Unplug the bottle tube connected
to the neck of the water bottle.
Plug the bottle tube using the red
plug provided in the SmartFlo™
replacement kit (Fig 3).
6. Remove the SmartFlo™ cartridge
and bottle tube by unlatching
the blue locking arm and rotating
the two blue knobs to the open
position (Fig 5).
7. Pull up on the SmartFlo™ water
cartridge (Fig 6). Do not squeeze
the water reservoir as water could
leak out.
WARNING: Always use caution when handling hot water.

SPARKLETTS Pure Water Dispenser 500 Series Specifications

General

Brand	SPARKLETTS
Model	Pure Water Dispenser 500 Series
Category	Water Dispenser
Language	English

Summary

How to Clean Your Water Dispenser

Prepare for Cleaning

Turn off the hot tank heater, unplug the unit, and let it cool.

Clean Dispenser Interior

Remove the water bottle and wipe the interior cabinet with disinfectant.

Disconnect Bottle Tube

Unplug the bottle tube and secure it with the provided red plug.

Prepare for Cartridge Removal

Remove cup holders and place a container to catch drips.

Remove Old SmartFlo Cartridge

Unlatch the blue arm and rotate knobs to remove the existing cartridge.

Install New SmartFlo Cartridge

Install the new bottle tube and cartridge, securing with locking mechanisms.

Prepare New Water Bottle

Unpack and install the bottle adaptor and tube into a new water bottle.

Connect Bottle to Dispenser

Remove the protective cap and install the bottle tube into the adaptor.

Clean Internal Components

Clean the cabinet, receptacle, and spigots with disinfectant wipes.

Clean Drip Tray and Grill

Empty and clean the drip tray and grill with mild soap or dishwasher.

Final Setup and Priming

Install a full bottle, turn on the hot water, and prime the dispenser.