To Next PageTo Next Page
Need help?Do you have a question about the Spaun Electronic SMS 9982 NF and is the answer not in the manual?
Covers DiSEqC multiswitches SMS 9962 NF, SMS 9982 NF, SMK 99xx F, CE marking.
Details screening requirements (EN 50083-2, Class A) and earthing terminal connection.
Install in dry rooms, non-combustible surfaces, ensure air circulation, -20°C to +50°C.
Setting LNB voltage and adjusting SAT IF/terrestrial input levels.
Usable as standalone, extension, repeater, or end-of-line multiswitches.
Internal energy-saving power supply and power consumption details.
Supports 12V, 18V, and 22kHz LNB supply modes.
Explains standby mode activation and its effect on amplifiers/voltage.
Adjustable attenuator, CATV amplifier, and bypass function.
Feed aerial signals via diplexers or multiband-amplifiers.
Level adjusters and max input level for IF signal equalization.
Correct connection of IF signals as shown on the multiswitch casing.
Max output levels for trunklines across various frequency ranges.
Table for derating max output level based on carriers and amplifiers.
Specifies tap loss for terrestrial (0 dB) and SAT (-3 to +4 dB) outputs.
Tap control logic, analogue signals for polarity, band, and satellite selection.
DiSEqC signals for control and usage of mode selectors.
DiSEqC support, address, and required trunkline termination (ZFR 75 DC).
Unused inputs/taps must be terminated for EMC conformity.
Passive modules for distribution, support terrestrial, require cascade termination.
Max 2-3 units; repeater needs; mode selectors available.
Table detailing technical specs for models SMK 9962 F to SMK 99169 F.
Frequency range, subscriber count, through loss, tap loss, isolation.
Current per receiver and physical dimensions.
General| Brand | Spaun Electronic |
|---|---|
| Model | SMS 9982 NF |
| Category | Switch |
| Language | English |
