Spearhead
Q2000HD, Q2500HD & Q2800HD Flail mower
7
Installing your machine
Introduction
The Spearhead Q2000HD, Q2500HD and Q2800HD are very robust high capacity flail mowers that
are easy to operate and maintain, but to ensure trouble-free operation this manual should be carefully
studied.
Safety First
Do not start the machine until you fully understand operation and safety precaution requirements.
Tractor requirements
n Spearhead strongly recommend 50 - 90hp 4 cylinder tractor with category 2 rear linkage.
n Minimum tractor weight including ballast must be 2500kg.
n PTO must be independent live drive to enable continuous PTO drive even when tractor clutch
is pressed down.
n Before hitching ensure position control is selected. Do not attempt to hitch in draft control.
n Check chains and stabilisers must be in good working order to hold the machine firmly.
Do not operate without checking that chains and stabilisers are tight.
n Spearhead particularly recommend ‘turn buckle’ type check chains.
n Set linkage lift rods to an equal length.