7. Tap again until the hour flashes and is displayed on the LCD. Use the or arrow to set the hour startProgram Night UP DOWN
time. Note: PM hours are indicated by on the LCD.PM
8. Tap again until the minutes flash. Use the or arrow to set the minutes.Program UP DOWN
9. Tap again and the heating setpoint will flash. You can use the or arrow to change the heating setpoint orProgram UP DOWN
use the factory default of 62 degrees.
10. Tap again and the cooling setpoint will flash. You can use the or arrow to change the cooling setpoint orProgram UP DOWN
use the factory default of 83 degrees.
11. Tap again and the fan option will flash. This is the correct setting for the Night mode. If not, use the orProgram Automatic UP
arrow to set the fan option from Always On to Automatic.DOWN
12. Tap again and (Copy) will appear on the LCD. If you wish to copy the Monday program to additional days of theProgram CPY
week, use the or arrow to add additional days. Example:UP DOWN Mon Tue Wed Thu Fri
13. Once you have selected the days to be copied, touch . will begin to flash and then the next programming day willProgram CPY
flash. Example: If you copy the Monday schedule through Friday, (Saturday) will flash. Simply repeat the programmingSat
steps for any day where the building will be unoccupied. The only required change is that both the and fan optionDay Night
should be set to and the heating and cooling setpoints for should reflect the unoccupied setpoints for .Automatic Day Night
14. Once programming is completed, make sure the thermostat is set in the mode of operation.Auto
TYPICAL 7-DAY SCHEDULE HAVING 2 EVENTS PER DAY WITH SATURDAY/SUNDAY UNOCCUPIED
PROGRAM DAY START TIME HEAT COOL FAN
SETPOINT SETPOINT
DAY MON 7:00 AM 70 75 Always On
NIGHT 5:00 PM 62 83 Automatic
COPY MONDAY PROGRAM TO TUESDAY, WEDNESDAY, THURSDAY AND FRIDAY
DAY SAT 7:00 PM 62 83 Automatic
NIGHT 5:00 PM 62 83 Automatic
COPY SATURDAY PROGRAM TO SUNDAY
To Next Page
Loading...