SPECS PU IQE 12/38 User Manual

PU IQE 12/38
Ion Source Power Supply
SPECS Surface Nano Analysis GmbH
Voltastrasse 5
13355 Berlin
Germany
Tel.: +49 30 46 78 24-0
Fax: +49 30 46 42 08-3
Email: support@specs.com
Web: http://www.specs.com ISO 9001 Certificate
Innovation in Surface Spectroscopyand Microscopy Systems
Customized Systems
and Solutions
Nanostrcutures and
Thin Film Deposition
Surface Analysis and
PreparationComponents
Surface Science
Applications

SPECS PU IQE 12/38 Specifications

General

Brand	SPECS
Model	PU IQE 12/38
Category	Power Supply
Language	English

Summary

Introduction to the PU IQE 12/38

Safety Instructions for Instrument Operation

Highlights important warnings and procedures for safe instrument operation.

Basic Operation of the Ion Source Power Supply

PU IQE 12/38 Installation Procedure

Details the procedure for installing the PU IQE 12/38 into a 19" rack.

Programming Source Specific Parameters

Explains how to program operating parameters for optimal source performance.

Switching On the PU IQE 12/38

Describes the general procedure for using the PU IQE 12/38 with the ion source.

Switching Off the PU IQE 12/38

Details the procedure for safely switching off the PU IQE 12/38.

Front Panel Control Guide

Front Panel Layout and Features

Explains the features and buttons located on the front panel of the PU IQE 12/38.

Understanding Operation Modes

Describes the four operational modes: Standby, Degas, Operate, and Off.

Operate Mode Details

Details how to start and operate the ion source in Operate mode.

Degas Mode Functionality

Explains the use of Degas mode to clean ionizer stage electrodes.

Viewing and Modifying Parameters

Guides on changing display content to view and modify parameters.

Storing and Recalling Parameter Sets

Details saving and retrieving parameter sets for experimental conditions.

Setting the Energy Parameter

Explains the Energy parameter defining the accelerated ions' energy.

Setting Up the Power Unit

Guides on fine-tuning operational parameters for proper unit function.

Setting the I Limit Filament Current

Sets the filament limit current, which cannot be exceeded.

Setting the I Standby Filament Current

Sets the current supplied to the filament in Standby mode.

Remote Control Capabilities

Available Interfaces for Remote Control

Details available interfaces for remote control of the PU IQE 12/38.

RS-232 Interface Configuration

Describes the RS-232 port and its settings for remote control.

Remote Control Commands

Lists commands used for remote control of the PU IQE 12/38.

Troubleshooting Common Issues

Identifying and Resolving Possible Problems

Summarizes common problems, their causes, and potential solutions.

Measuring Power Unit Voltages

Guides on performing checks on output voltages for correct operation.

Checking Energy Voltage

Describes how to check the energy voltage level.

Checking Extractor Voltage

Describes how to check the extractor voltage level.

Replacing the Internal Fuse for Degas Mode

Guides on replacing the internal fuse for Degas mode.

Understanding and Resolving Error Messages

Lists various error messages and their explanations.

Technical Description and Specifications

Technical Specifications of the PU IQE 12/38

Lists main physical specifications and requirements of the PU IQE 12/38.

Output Voltages Summary

Summarizes voltages generated by the PU IQE 12/38 and their limiting values.

System Connections Overview

Describes connectors on the rear panel and pins on the output cable.

Rear Panel Layout and Connectors

Shows the rear panel layout and its connectors.