Activating/Deactivating Standby mode
Standby mode helps to increase the battery life and
controls the laser setup during breaks. The self-leveling
and rotation will be stopped and the beam will be turned
off while the HI alert is still active.
Press and hold the button at the laser or remote
control for 3 seconds activates the Standby mode.
The HI/MAN LED at the laser flashes red every 5
seconds while the RC402N display shows Standby.
To deactivate Standby mode and restore full
operation of the laser, press and hold the button
at the laser or remote control again for 3 seconds.
To Next Page
Loading...
