3. Press and release the button and select
>>PlaneLok<<.
4. Press and release button to open the PlaneLok
submenu; then press button to start PlaneLok (PL Y)
.
5. The laser starts to search for the receiver while
the RC402N display shows flashing PL.
The HL760 display shows a flashing –PL–
during the time the laser is searching and
adjusting the beam to the on-grade position.
6. When PlaneLok is complete, –PL– stops flashing
at the HL760 and RC402N display.
Automatic Horizontal-PlaneLok
To Next Page
Loading...
