When setting up the transmitter vertical,
PlaneLok can be used at the X-axis.
1. Press and release the button
and select >>PlaneLok<<.
2. Press and release button to open the PlaneLok submenu;
select the X-axis; then press button to start PlaneLok.
Note: When used in vertical mode, the receiver has to be placed with the photocell
on the bottom side. For getting the best performance and a longer operating range
set up the HL760 at least 0.5 m (2 ft) above the ground.
Any loss of signal over an extended period of time (1 minute) causes the laser to go
into the HI-alert condition (beam turns off, rotor stops and a warning message
occurs at the LCD). PlaneLok mode can be reactivated after the Error message has
been deleted with the button.
Exiting of PlaneLok can be done by pressing the button or any
HL760 button where the unit goes always back to automatic mode.
Automatic Vertical-PlaneLok
To Next Page
Loading...
