Spectra Precision HV302 - Line Scan using the RC402 N menu; RC402 N Line Scan Operation

When setting up the unit vertical, Line Scan centers the
rotor horizontally and can be used to align the laser
reference to a desired line position.
 Press and release the button at the Standard Display
and select >>Line Scan<<.
 Press and release the button starts Line Scan.
The rotor checks the limits of the X- axis and stops at the center position in
automatic mode. (LS is flashing while all laser LEDs are
turned off)
Pressing the button at the laser or RC402N stops the movement and
changes the unit into manual mode.
Line position corrections left and right can be done using buttons.
Press and release the button at the laser or RC402N to
change the unit back to full automatic mode.
Line Scan using the RC402N menu