Spectra GOLF User Manual

Spectra Lighting Sp. z o.o.
ul. Ostródzka 53
03-289 Warszawa
www.spectra-lighting.pl
tel: (0-22) 567 01 00
fax: (0-22) 567 01 01
e-mail: ofce@spectra-lighting.pl
NIP: 525 224 65 65
MOUNTING INSTRUCTION SHEET
GOLF
1. General
To ensure correct use, please read these instructions carefully.
• All luminaires must be installed by a qualied electrician.
• Installation and replacement of damaged luminaires, cleaning and other service works must be carried out by
a qualied personnel with power disconnected.
• Make sure the cables are connected to the corresponding connector terminals. For luminaires with emergency
power module, use an additional connector between the battery and the converter.
L
N
PE
Connect power supply to the bracket
Mount the suspension bracket
L
N
EVG
DALI/
1-10V
EVG
DA+ - Dali + / 1-10V +
DA- - Dali - / 1-10V -
L
N
DA+
DA-
1 2 3
5 6
7
4
8
Turn on power supply
ON
OFF
GOLF
Trace and drill the mounting holes
40
Tighten the screw
Mount light source
Place the holder in the diffuser

Spectra GOLF Specifications

General

Brand	Spectra
Model	GOLF
Category	Outdoor Light
Language	English

Summary

General Mounting Instructions

General Safety and Installation Notes

All luminaires must be installed by qualified electricians and serviced with power disconnected.

GOLF Luminaire Installation Steps

Trace and Drill Mounting Holes

Mark and drill holes accurately for mounting the luminaire on the ceiling.

Mount Suspension Bracket

Securely attach the suspension bracket to the prepared mounting location.

Connect Power Supply

Connect the power supply cables to the luminaire's bracket terminals.

Mount Light Source

Install the light source component into the luminaire body.

Place Holder in Diffuser

Insert the holder into the diffuser component as per instructions.

Tighten Screw

Ensure all connections and components are securely tightened.

Turn on Power Supply

Activate the power supply to test the luminaire's functionality.

Maintenance and Cleaning

Routine Inspection and Maintenance

Inspect fittings for malfunctions or damage during operation and replace parts as needed.

Cleaning Optical Components

Clean optical parts using anti-static wipes, mild soap, or ultrasonic cleaning.

Prohibited Cleaning Agents

Avoid acrylic polishes and products containing Methanol, Isopropyl, Acetone, or MEK.

Usage and Installation Precautions

Handling Optical Components

Handle optical components with care, using clean cotton gloves.

Installation During Construction

Protect components from dust, waxes, and paint during installation.

Environment Restrictions

Avoid environments with oils, chlorinated hydrocarbons, or excessive heat.