Need help?Do you have a question about the Spectron Toys Drawbot DRWBT and is the answer not in the manual?
Drawbot utilizes an optical sensor to read black lines drawn on paper.
Lines must be at least a quarter inch (1/4") thick and fully filled for optimal performance.
Use the Drawbot marker to draw a line on a white piece of paper as instructed.
Turn on the switch located at the bottom of the Drawbot to begin play.
Use a small screwdriver to open the lid at the back of the Drawbot.
Requires 4 new button cell batteries, specifically LR 1.5V (4xLR44 included).
Draw thicker lines if Drawbot strays; use the exclusive Drawbot Marker for best results.
Do not use in direct sunlight, near daylight lamps, or on glossy paper.
Do not mix old/new, recharge non-rechargeable, remove rechargeable before charging, remove exhausted batteries.
Avoid short-circuiting terminals, use equivalent types, ensure correct polarity, do not swallow.
Challenge your Drawbot to follow custom fun trails and paths.
Collect all 6 Drawbots for races or chases against each other.
Connect paper sheets, draw complex highways, or create a Drawbot city.
Do not dispose of batteries in household waste; use local collecting points for safe recycling.
Dispose of electrical appliances separately at local collecting points for proper recycling.
Remove batteries when not in use, wipe gently with a damp cloth, and use indoors only.
Do not submerge the toy in water, as it can damage the electronic assemblies.
Parental guidance is recommended when installing or replacing batteries.
Users should retain this information for future reference and follow manual instructions.
General| Brand | Spectron Toys |
|---|---|
| Model | Drawbot DRWBT |
| Category | Toy |
| Language | English |
To Next Page
