228
Step Action Value(s) Yes No
8
Remove all test equipment except the moni-
tor.
Using the monitor, reset the adaptive learn.
Connect any disconnected components, fus-
es, etc.
Using the monitor, clear DTC information
from the ECM.
Turn the ignition OFF and wait 30 seconds.
Start the engine and operate the vehicle to
full operating temperature.
Observe the MIL.
Observe engine performance and driveabili-
ty.
After operating the engine within the test pa-
rameters of code, check for any stored
codes.
Does the engine operate normally with no stored
codes?
System OK.
Go to On-
Board Diag-
nostics
System
Check/Malfun
ction Indicator
lamp.
To Next Page
Loading...