253
Fuel Filter and slide out.
7. Discard Fuel Filter.
INSTALLATION PROCEDURE
1. Slide the Fuel Filter inside the cushioned
clamp and tighten.
2. Place clamps over hoses.
3. Connect hoses to the Fuel Filter.
4. Tighten hose clamps on Fuel Filter.
5. Retighten clamp securing Fuel Filter.
6. Connect negative battery cable.
7. Open LPG fuel valve on tank.
IMPORTANT:
The fuel cylinder manual valve contains an
Excess Flow Check Valve. Open the manual
valve slowly to prevent activating the Excess Flow
Check Valve.
8. Turn Key to ON. Check for leaks at the inlet
and outlet fittings, and the filter housing end
connection using a soapy solution or an elec-
tronic leak detector. If leaks are detected
make repairs.
9. Start engine and check for leaks once more.
XXXIV. PCV
REMOVAL
1. Remove Hose Clamp on Hose connected to
PCV and remove Hose.
2. While gently rocking back and forth, pull PCV
from its mounting gasket and remove.
To Next Page
Loading...