0118583R6 Page 3 of 4
Figure 4
Upright bracket
Upright
assembly
1/4-20 x 15mm JC
bolts (4 required)
End cap
Figure 5
Upright opening
Monitor
mounting plate
1/4-20 x 15mm
JC bolts
(4 required)
6. Attach the upright bracket to the upright assembly as shown using
(4) 1/4-20 x 15mm JC bolts and tighten securely. (Multiple mounting
holes / height positions are available on the upright assembly).
Figure 4.
1. Refer to the instructions included with the monitor mount for complete
monitor installation procedure.
2. Install the monitor mounting plate to the upright bracket with (4) 1/4-
20 x 15mm JC bolts and tighten securely. Figure 5.
3. Install monitor and route wiring through the upright opening.
4. Install end cap on top of upright.
• Refer to the instructions included with the monitor mount for
complete monitor and security rod installation procedure.
• The assembled display stand accommodates most 37”-70”
monitors.
• Be sure your monitor does not exceed the weight capacity of 125 lb.
WARNING
The monitor should always be removed
from the stand before moving the unit.
Hanging rail
To Next Page
Loading...