NOTICE
Clean the Airbrush IMMEDIATELY after use.
Delayed or inadequate cleaning will permanently clog the Airbrush.
Page 7For technical questions, please call 1-888-866-5797.Item 70130
SAFETYOPERATIONMAINTENANCE INSTALLATION
Operating Instructions
Read the ENTIRE IMPORTANT SAFETY INFORMATION section at the beginning of this
manual including all text under subheadings therein before set up or use of this product.
Work Area Set Up
1. Designate a work area that is clean and well‑lit.
The work area must not allow access by children
or pets to prevent distraction and injury.
2. Locate the Air Compressor on a flat level
surface to ensure proper pump lubrication and
to prevent damage to the unit. Keep at least 12″
of space around the unit to allow air circulation.
3. Route the power cord from the Air Compressor
to the grounded wall outlet, along a safe path
without creating a tripping hazard or exposing
the power cord to possible damage.
4. Before spraying, mask nearby objects not being
sprayed and lay cloths (not included) on the floors.
Air Connection Setup
1. Connect included Quick Connect fitting to Air Inlet.
2. Connect air hose (not included) to Quick Connect.
3. Connect air hose to air outlet on the compressor.
4. The air hose must be able to reach work
area with enough extra length to allow
free movement while working.
General Compressor Operation
1. Turn on air compressor according to
air compressor instructions.
2. While the system is pressurized, check for air
leaks by listening for air hissing and by feeling
around connections. If a leak is detected, tighten
connections. Do not use the air compressor unless
all connections are air tight, the extra air leaking
out will cause the air compressor to operate more
often, increasing wear on the air compressor.
WARNING! TO PREVENT SERIOUS
INJURY AND DEATH FROM
EXPLOSION:
Do not adjust the internal
pressure switch. Any change to the
automatic pressure levels may cause excess pressure
to accumulate, causing a hazardous situation.
To Next Page
Loading...