3) Remote Control Instruction
Install Batteries
1) Open back cover of battery component on the back of
remote control.
2) Install AAA type battery according to the corresponding
electrode, make sure battery positive and negative pole are
correct ("+"to"+", "-" to "-"), please do not mix using old and
new batteries.
3) After battery is installed, close the back cover of battery
components, and make the following clip buckled to the
bottom.
Range of remote control
Remote control can work normally within the range of 8 meters
distance, 30 degrees left and right from the remote-control
receiver; in order to protect environment, please dispose waste
battery into recycling box.
If the battery is replaced by an incorrect type, it
may lead to explosion.
11
Speechi 2022
To Next Page
Loading...