What to do if my Speed Passion Engine runs in the opposite direction?
If your Speed Passion Engine runs in the opposite direction, the wire connections between the ESC and motor may need to be changed. Swap any two wire connections between the ESC and motor. Note that this only applies to sensorless motors.
What to do if my Speed Passion Engine's speed is lower than normal and the red LED is blinking?
If your Speed Passion Engine suddenly stops running, or its speed is lower than normal, and the red LED is blinking, the ESC may have entered low voltage protection mode. Replace the battery pack to resolve this issue.
What to do if my Speed Passion Reventon's speed is lower than normal and the orange LED is blinking?
If your Speed Passion Engine suddenly stops running, or its speed is lower than normal, and the orange LED is blinking, the ESC may have entered over-heat protection mode. Install a fan for cooling it down. Alternatively, you can turn off over-heat protection, but be aware that overheating could damage the ESC.
What to do if my Speed Passion Engine's speed is lower than normal and both orange and red LEDs are blinking?
If your Speed Passion Engine suddenly stops running, or its speed is lower than normal, and both the orange and red LEDs are blinking, the sensor wire might be disconnected. Ensure the sensor wire is connected and not damaged, and that it makes good contact.
What to do if my Speed Passion Engine has random stops because of strong electromagnetic interference?
If your Speed Passion Engine experiences random stops, restarts, or irregular operation due to a strong electromagnetic interference field, reset the ESC to resume normal operation. If this doesn't work, move to another area to operate the car.
Connect ESC, motor, receiver, and battery according to the diagram.
Describes alert tone for abnormal input voltage, indicated by flashing red LED.
Covers low voltage cut-off, overheat protection, and throttle signal loss protection.
Details the 6V heat sink fan for cooling ESCs, compatible with specific battery types.
Guide for programming ESC via PC software and updating ESC firmware.
Presents a table of programmable items and their available settings for the ESC.
Details the various programmable parameters like Running Mode, Timing, and Response Systems.
Instructions for connecting and operating the LCD program card for ESC configuration.
Illustrates examples of fine-tuning and custom programming ESC parameters.
General| Type | Brushless |
|---|---|
| Forward/Brake/Reverse | Yes/Yes/Yes |
| BEC Current | 3A |
| Weight | 45g |
| Sensor | Yes |
| BEC Voltage | 6V |
To Next Page
