Display: Red blinking red indicates a fault occurs, and the speedometer displays the
fault code. Please contact after-sales service.
Temperature warning: Blinking means the battery temperature reaches 55
ȭ
or lower
than 0
ȭ
.
Battery display: each sector represents about 20% of the battery.
Bluetooth
Cruise
Car lock
Gear
Long press: Power on/off
Short press: front/rear lights on/off
Double click: Mode switch
* In this status, the scooter's acceleration power is reduced and it may not be able to
recharge. Please leave the scooter to room temperature before charging.
* The last sector display in red, indicating that the battery power is very low , please
charge in time.
Speed display
Headlight on/off display
Mileage display
Power display
4. Display & Switch & APP
Power: long press for power on/off
Under power on status, 1 click for front and rear light on/off
Double click: gears mode swiching
Trible click: Km/hr and Miles/hr speed unit switching.
Quardra click: single mileage/total mileage conversion.
Speedometer: shows the current speed of the scooter. When the malfunction occurs, the
speedometer displays the failure code.
Speed mode: Three modes are available. The maximum speed of each mode is shown in
the table below.
Mode Gears Speed
1 low speed gear 15KM/H
Medium gear 25KM/H
high speed gear 32KM/H
2
3
APP
1. Caution Before using the APP :
(1) TUYA App-There are safety risks when learning to ride the e-scooter. You must
read the Riding Safety via the App before your first ride.
(2) Because TUYA APP has some functions that need to get your phone's permission,
so please choose according to your needs.
(3) Since TUYA APP is an integrated APP for smart home devices.You can not only use
it to control the electric scooter, you can also use it to control other smart appliances
at home that cooperate with TUYA APP.
2. Download : You can download TUYA APP from APP Store or google search.
3.
Note:
Connect : To connect the scooter to TUYA APP, you need to turn the scooter on and
then turn on the Bluetooth of your phone. Finally, open TUYA APP and click the
scooter icon. You can then enter the control interface of the scooter, which includes
the following functions: constant speed cruise, light switch, gear setting, single
mileage, total mileage, scooter lock, scooter power display, Bluetooth connection
status, etc.
If the scooter device has not been searched, you need to reset the connection of the
scooter. Operation method of reset
:
Hold the brake tightly, pinch the bottom to do
so, and then press the power on button 5 times in a row to complete the reset, and
then try to reconnect as above.
The lock function can only be used on the phone. On the electric scooter body can
not be operated to lock, or unlock. Because the main purpose of the lock function is
to prevent theft.
1.
2.
mph
km/h
Trip
ODO
Mile
Km
To Next Page
Loading...