6. How to ride
Fold the handlebar post
and snap the hook into the
buckle on the rear fender.
1. Slide: Stand on the stand pad with
one foot and kick back with the other.
3. Deceleration: release accelerator lever
and/or grip the brake level.
4. Turn: Tilt your barycenter slightly and slowly turn
the handle bar.
2. Acceleration: Stand on the foot pad and balance, and
press the accelerator lever with your right thumb.
*
Motor start requirements: speed ≥3km/h.
Wear a helmet at all
times while riding.
Riding on public vehicle roads, motorways
and highways are prohibited.
Do not use mobile phones or
wear headphones while riding.
3. Folding
1. Make sure the power is off.
2. Press the safety buckle with your thumb and pull the quick release lever
backward.
3. Fold the pole down to the rear fender.
4. Snap the hook into the buckle on the rear fender.
Check the battery power before riding . If the battery is low, charge it immediately.
Warning: Serious injury may result from falling due to lack of tyre grip when panic
stop . Please keep a safe braking distance and observe road conditions .
Slow down and brake to avoid potential risks .
*
7. How to Charge
8. Safty Risks
Please do not charge when the charging port, charger or power outlet are damp.
When charging, only use the original charger provided by us. Do not use the charger
of any other model.
If the battery is damaged or flooded, do not charge or continue to use the battery.
Before charging or after charging, fasten the rubber plug of charging port.
Please do not charge outside.
1) Remove the rubber
cover on the scooter
charging port.
2) Plug the charger plug
into the port and then
connect charger with the
power supply.
3) After charging,
put the rubber cover
back in place.
Warning
Serious injury may occur if you do not follow the following safety tips. All property
losses and personal injuries caused by this will be borne by the user.
To Next Page
Loading...