Speedtech Instruments Angleris EDGE PLUS - Page 7

3. The minutes will flash. Press the – or +
button to set the current minute. Press the SET
button to confirm.
4. The month will flash. Press the – or +
button to set the current month. Press the SET
button to confirm.
5. The day will flash. Press the – or + button
to set the current day. Press the SET button to
confirm.
6. The year will flash. Press the – or + button
to set the current year. Press the SET button to
confirm. Skip to 9 for future mode.
7. (present mode only) The pressure unit
(inHg or mb) will flash. Press the – or + button
to select inHg or mb. Press the SET button to
confirm.
8. (present mode only) The altitude unit will
flash. Press the – or + button to select ft or m
(meters). This is for the altitude input for
pressure adjustment. Press the SET button to
confirm.
9. The time zone will flash. Press the – or +
button to set the local time zone. Press the SET
button to confirm.
10. The latitude direction will flash. Press the –
or + button to set N (North) or S (South). Press
the SET button to confirm.
11. The latitude degrees will flash. Press the –
or + button to set the latitude degrees. Press the
SET button to confirm.
12. The latitude minutes will flash. Press the –
or + button to set the latitude minutes. Press the
SET button to confirm.
13. The minutes will flash. Press the – or +
button to set the current minute. Press the SET
button to confirm.
14. The longitude direction will flash. Press the
– or + button to set W (West) or E (East). Press
the SET button to confirm.
15. The longitude degrees will flash. Press the –
or + button to set the longitude degrees. Press
the SET button to confirm.