BINDING A RECEIVER
1. With the receiver off insert the bind plug into the BND
port on the receiver.
2. Power the receiver through any other port. The amber
LED will flash continuously, indicating the receiver is
in bind mode.
3. With the steering wheel, throttle trigger and Aux
channel (if applicable) in the desired preset failsafe
positions, press and hold the bind button and turn
on the transmitter. The red LED on the front of
the transmitter will flash within a couple seconds
indicating the transmitter is in bind mode. Once the
red LED begins flashing, release the bind button.
Bind Plug LED
4. Within 15 seconds, the LED on the receiver will go
solid indicating a successful bind has taken place.
5. Remove the bind plug and store it in a convenient
place.
Note: You must rebind when:
•Differentfailsafepositionsaredesired,e.g.when
throttle or steering reversing has been changed.
•Changingreceivertypes,e.g.changingfromaDSM
receiver to a DSM2 or Marine receiver.
•Thereceiveristobeboundtoadifferenttransmitter.
Note: Some Spektrum receivers, like the SR3000, use a
bind button rather than a bind plug. The binding process
is the same with this receiver; however, instead of
inserting the plug before powering up the receiver, press
and hold the bind button while powering up the receiver
to enter bind mode.
Bind Plug
LED
To Next Page
Loading...
Need help?
General
