EN
10
Gain Adjustment
The main Forward Programming displays flight control adjustments under
Swashplate and Tailrotor.
Tip: Adjust gains per flight mode by setting the SetupFM Channel:
Function in the setup menu. Set the Channel Input Config in the transmitter
for the selected channel to Flight Mode.
After the tail gains are fairly close, use the transmitter gyro gain function to
adjust the gain for each flight mode.
1. Cyclic P Gain Adjustment (Default 50%)
Higher gain will result in greater stability. Setting the gain too high may
result in random twitches if your model has an excessive level of vibration.
High frequency oscillations may also occur if the gain is set too high.
Lower gain will result in less stability. Too low of a value may result in a less
stable model, particularly outdoors in winds.
If you are located at a higher altitude or in a warmer climate, higher gains
may be beneficial—the opposite is true for lower altitude or colder climates.
2. Cyclic I Gain Adjustment (Default 50%)
Higher gain will result in the model remaining still, but may cause low
frequency oscillations if increased too far.
Lower gain will result in the model drifting slowly.
If you are located at a higher altitude or in a warmer climate, higher gains
may be beneficial—the opposite is true for lower altitude or colder climates.
3. Cyclic D Gain Adjustment (Default 7%)
Higher gain will improve the response rate of your inputs.
If the gain is raised too much, high frequency oscillations may occur.
Lower gain will slow down the response to inputs.
SMART Technology Telemetry
Spektrum SMART Technology provides telemetry information including battery
voltage and temperature.
A firmware update for your transmitter may be required.
To view SMART Telemetry:
1. The SMART Logo appears under the battery logo on the home page. A
signal bar appears in the top left corner of the screen.
2. Scroll past the servo monitor to view SMART technology screens.
For more information about compatible transmitters, firmware updates,
and how to use the SMART Technology on your transmitter, visit
www.SpektrumRC.com.
To Next Page
Loading...
Need help?
General
