WORKS WITH SELECT ETCHED/WAFER-THIN DIES
WITH GLIMMER HOT FOIL SYSTEM
Plug in, turn on Machine and wait
for it to heat up. The Platform Ready
Light Indicator will turn green.
Place Glimmer Foil (shiny side
facing down) on the etched die.
Remove the whole Platform and
sandwich and roll it slowly through
the Spellbinders
®
Platinum
™
Machine
or any other approved die-cutting
machine and back.
Remove Shims. Place the Platform
back in base. Slowly peel Foil from
material and enjoy the lovely foil
finish on your material.
Place Etched/Wafer-thin die on the
heating surface. Press Timer button
and wait until it turns solid green.
Add desired material and the necessary
Shims. See Material chart below.
Material Chart
Glimmer Thin Shim Glimmer Spacer Pad
Cutting Plate
(from Die-Cutting Machine)
Cardstock
Watercolor Paper
Chipboard
Fabric
Ribbon
Leather
5
Visit our YouTube playlist for Glimmer Hot Foil System at https://goo.gl/YMKeFt
To Next Page
Loading...