To Next Page
D
diananelsonAug 8, 2025
Why is irrigation not carried out with spherag Controller?
- RRonald ClementsAug 8, 2025
Irrigation might not occur due to several reasons. One cause could be driver failure from bypassing the red and black wires during an open or close command. In this case, send the device to its supplier or directly to Spherag’s facilities for analysis. If the failure is due to manufacturing defects, it will be repaired. However, if it results from a short-circuit, the failure is irreparable, and SPHERAG assumes no liability. Another reason may be an empty battery; ensure you follow the installation guidelines (Step 5). Also, the program might not be received on the device due to poor signal quality, so placing it in a higher location could improve signal reception.
General