Spider Gear SpiderPro - Holster Lock Operation; Secure and Quick-Draw Lock Mechanism; SpiderPro Plate Details; Plate Design and Features

FOR SECURITY UNDER ALL CONDITIONS
THERE ARE THREE LOCKS ON THE BELT BUCKLE
1
3
2
SPIDERPRO BELT
INSERT THE PAD EARS UNDER
THE OUTER BELT WEBBING
AFTER BELT SIZING:
BE SURE TO POSITION THE BELT PADDING WHERE
YOU WANT THE SECOND HOLSTER TO BE LOCATED.
SLIDE THE HOLSTER CLIP THROUGH THE GAP IN
THE BELT PADDING AS SHOWN
ADDING A SECOND HOLSTER
(DUAL CAMERA SYSTEM)
1
2
3
BELT SIZING
PEEL APART THE VELCRO WEBBING AND
ADJUST THE SIZE UNTIL IT FITS SNUGLY
ON YOUR HIPS
POSITION THE BELT PADDING OVER YOUR LEFT HIP
RECONNECT THE VELCRO WEBBING
1
2
3
SPIDERPRO PLATE
WRENCH STOWS
IN THE PLATE
ANTI-TWIST
PIN DESIGN
THREADED HOLES
FOR TRIPODS
LENS
*ANTI-ROTATION FEATURES
KEEP THE PLATE ALIGNED
WITH YOUR CAMERA...
...MAKE SURE THEY ARE TIGHT
AGAINST THE CAMERA BODY
ANTI-SLIP
RUBBER GRIPS
ANTI-ROTATION
FEATURES*
6
5
4
HOLSTER LOCK OPERATION
1
1
2
SECURE: LOCK ENGAGES EVERY TIME
QUICK-DRAW: LOCK IS DISENGAGED
ROTATE UPWARDS
TO REMOVE CAMERA
1
CONTINUE ROTATING TO
UNLOCK THE HOLSTER
FOR QUICK-DRAW
2
4
5
6