Spinlock deckware Series - Safety Notices; Fitting Adjustments; How to Use; Cleaning, Maintenance, Storage

14
2. Make sure the manual lever is in the
up and ready position. Install the CO2
cylinder into the inflator by screwing it
until hand-tight (Fig.2). Check that the
automatic capsule has not been fired by
ensuring that the bottom indicator is
showing green.
3. Check that the oral-inflation tube
cap is in stowed position B (Fig.3).
A Dust cap in deflate position
B Dust cap in stowed position
4. Ensure the cord runs freely
from the firing head to the
eyelet in the cover. Re-fasten
the zipper. If everything
conforms to the preceding
instructions, your lifejacket
is ready for use. Re-run the
zip back around the cover to
close (Fig.4).
Fig. 4
Fig. 2
Fig. 3
A B