Spinlock deckware Series - Re-arming and Re-packing Your Lifejacket

13
Re-arming and re-packing your lifejacket after inflation
1 33 g CO2 cylinder
2 Automatic firing capsule
3 United Moulders
Pro Sensor
®
inflator
4 Valve retaining nut
5 Manual firing lanyard
6 Activation indicator window
All Green - ready to go
Red - needs rearming
1
2
3
4
5
Examine the automatic capsule.
Ensure that the cap is screwed
hand tight onto the inflator.
Check the components and assemble the inflator following these steps:
1. Unscrew and remove the 33g
CO2 gas cylinder from the inflator
and inspect its piercing cap. If it has
been pierced, replace it! (Fig.1).
Fig. 1
6