31
CONTAINS 1 X 3.7V/500 MAH LIPO BATTERY. REQUIRES 3
LR44 BATTERIES (INCLUDED).
BATTERIES OR BATTERY PACKS MUST BE RECYCLED OR
DISPOSED OF PROPERLY. WHEN THIS PRODUCT HAS
REACHED THE END OF ITS USEFUL LIFE IT SHOULD NOT
BE DISPOSED OF WITH OTHER HOUSEHOLD WASTE.
THE WASTE ELECTRICAL AND ELECTRONIC EQUIPMENT
REGULATIONS REQUIRE IT TO BE SEPARATELY COLLECTED
SO THAT IT CAN BE TREATED USING THE BEST AVAILABLE
RECOVERY AND RECYCLING TECHNIQUES. THIS WILL
MINIMIZE THE IMPACT ON THE ENVIRONMENT AND
HUMAN HEALTH FROM SOIL AND WATER CONTAMINA
-
TION BY ANY HAZARDOUS SUBSTANCES, DECREASE THE
RESOURCES REQUIRED TO MAKE NEW PRODUCTS AND
AVOID USING UP LANDFILL SPACE. PLEASE DO YOUR
PART BY KEEPING THIS PRODUCT OUT OF THE MUNICI
-
PAL WASTE STREAM! THE “WHEELIE BIN” SYMBOL MEANS
THAT IT SHOULD BE COLLECTED AS “WASTE ELECTRICAL
AND ELECTRONIC EQUIPMENT”. YOU CAN RETURN AN
OLD PRODUCT TO YOUR RETAILER WHEN YOU BUY A
SIMILAR NEW ONE. FOR OTHER OPTIONS, PLEASE CON
-
TACT YOUR LOCAL COUNCIL.
SPECIAL LIPO BATTERY INSTRUCTIONS:
NEVER CHARGE BATTERY UNATTENDED.
CHARGE BATTERY IN ISOLATED AREA. KEEP AWAY FROM
FLAMMABLE MATERIALS.
DO NOT EXPOSE TO DIRECT SUNLIGHT.
THERE IS A RISK OF THE BATTERIES EXPLODING, OVER
-
HEATING, OR IGNITING. DO NOT DISASSEMBLE, MODIFY
HEAT, OR SHORT-CIRCUIT THE BATTERIES. DO NOT PLACE
THEM IN FIRES OR LEAVE THEM IN HOT PLACES.
DO NOT DROP OR SUBJECT TO STRONG IMPACTS.
DO NOT ALLOW THE BATTERIES TO GET WET.
ONLY CHARGE THE BATTERIES WITH THE SPECIFIED SPIN
MASTER™ BATTERY CHARGER.
ONLY USE THE BATTERIES IN THE DEVICE SPECIFIED BY
SPIN MASTER™.
CAREFULLY READ THE INSTRUCTION GUIDE, AND USE
THE BATTERIES CORRECTLY.
IN THE UNLIKELY EVENT OF LEAKAGE OR EXPLOSION
USE SAND OR A CHEMICAL FIRE EXTINGUISHER FOR THE
BATTERY.
BATTERIES MUST BE RECYCLED OR DISPOSED OF
PROPERLY.
PRODUCT BATTERY REMOVAL INSTRUCTIONS:
INTERNAL BATTERY IS FACTORY INSTALLED AND NON-RE
-
PLACEABLE, PRODUCT DISASSEMBLY AND BATTERY
REMOVAL MUST BE PERFORMED BY AN ADULT. DO
NOT PUNCTURE, CUT, TEAR, COMPRESS OR DEFORM
PRODUCT DURING DISASSEMBLY. ENSURE PRODUCT IS
TURNED OFF, THEN USE A SCREW DRIVER TO REMOVE
ALL SCREWS. SEPARATE PRODUCT BODY HALVES TO EX
-
POSE INTERNAL ELECTRONICS. WHEN BATTERY IS VISIBLE
IN ITS ENTIRETY USE SCISSORS TO CUT A SINGLE BATTERY
WIRE, IMMEDIATELY WRAP THE CUT WIRE END WITH TAPE
TO ISOLATE IT, REPEAT UNTIL ALL BATTERY WIRES ARE CUT
AND ISOLATED, AND THE BATTERY IS FREE FROM THE
REST OF THE PRODUCT. DISPOSE OF BATTERY IN ACCOR
-
DANCE WITH YOUR LOCAL BATTERY RECYCLING OR
DISPOSAL LAWS. NOTE: OPENING OF PRODUCT AND/
OR REMOVAL OF BATTERY WILL RENDER PRODUCT IN
-
OPERATIVE AND VOIDS MANUFACTURER WARRANTIES,
DISPOSE OF REMAINING PRODUCT COMPONENTS IN
ACCORDANCE WITH LOCAL LAWS.
An Adult should periodically check this toy to ensure
no no damage or hazard exists. If so, remove from use.
Children should be supervised during play.
To Next Page
Loading...