IM-P408-04 AB Issue 2
2
2. Safety information
Safe operation of this product can only be guaranteed if it is properly installed,
commissioned, used and maintained by qualified personnel (see the following sections)
in compliance with the operating instructions. General installation and safety
instructions for pipeline and plant construction, as well as the proper use of tools and
safety equipment must also be complied with.
In the UK, your attention is drawn to IEE Regulations (BS 7671). Elsewhere, other
regulations will normally apply.
All wiring materials and methods shall comply with relevant EN and IEC standards
where applicable.
Warning
This product is designed and constructed to withstand the forces encountered during
normal use. Use of the product other than as a steam energy monitor, or failure to install
the product in accordance with these Instructions, product modifications or repair could:
- Cause damage to the product / property.
- Cause injury or fatality to personnel.
- Invalidate the marking.
Isolate the mains supply before opening the product as hazardous voltages may be
exposed.
These instructions must be stored in a safe place near the installation of the steam
energy monitor at all times.
Warning
This product complies with the requirements of the following directives and
harmonized standards:
Low Voltage Directive ( 2006 / 95 / EC) by meeting the standards of:
- EN 61010-1 Safety requirements for electrical equipment for measurement, control
and laboratory use.
Electromagnetic Compatibility (2004 / 108 / EC) by meeting the standards of:
- Immunity EN 61326-1 Table 2
- Radiated and conducted emissions EN 55011 and EN 55022 to Class B.
The product may be exposed to interference above the limits of EN 61326 if:
- The product or its wiring is located near a radio transmitter.
- Excessive electrical noise occurs on the mains supply. Power line protectors (ac)
should be installed if mains supply noise is likely. Protectors can combine filtering,
suppression, surge and spike arrestors.
- Cellular telephones and mobile radios may cause interference if used within
approximately 1 metre (39") of the product or its wiring. The actual separation
distance necessary will vary according to the surroundings of the installation and the
power of the transmitter.
To Next Page
Loading...