SpiroHome Clinic - User Manual

Questions and Answers

D
David SantosAug 15, 2025
Why SpiroHome Clinic Measuring Instruments cannot connect to Bluetooth?
- Z
  zacharykingAug 15, 2025
  If your SpiroHome Clinic measuring instrument won't connect to your smart device via Bluetooth, it could be due to several reasons. First, ensure your smart device is within range of the SpiroHome device. Second, verify that Bluetooth is enabled on your smart device. Finally, confirm that your smart device has Bluetooth version 4.0 or higher and select SpiroHome Clinic from the list of detected devices.
R
Ruth CrawfordAug 18, 2025
What to do if SpiroHome Clinic device not turning on?
- P
  Patrick KingAug 18, 2025
  If your SpiroHome Measuring Instruments device isn't turning on, there are a few things you can check: * Ensure the batteries are correctly oriented, paying attention to the polarities. * Remove the AAA batteries, wait 30 seconds, and then reinstall them. * Try replacing the AAA batteries with a new set. * Make sure the battery cap is in the locked position. If the cap is broken, contact the manufacturer.
S
Sarah WilliamsAug 21, 2025
What to do if SpiroHome Clinic test results are inconsistent?
- D
  derekjenkinsAug 21, 2025
  Inconsistent test results from your SpiroHome Measuring Instruments could stem from several issues. If the Spiroway mouthpiece is dirty, clean it if the same patient is using it, ensuring the lumen isn't blocked, or replace it. Replace the Spiroway if it's damaged. Ensure correct installation of Spiroway by consulting the user manual. If the device has lost calibration, perform the Calibration-Check; if errors persist, contact the manufacturer.
T
Tiffany HansenAug 25, 2025
What to do if measurement error screen showed up on SpiroHome?
- D
  Donald ClarkAug 25, 2025
  If a measurement error screen appears on your SpiroHome, it could be due to several reasons. It may be caused by exceeding the flow limit (this device is intended to measure 0-14 L/s). Alternatively, it could be due to a dirty or damaged Spiroway mouthpiece, in which case you should replace it. If none of these apply, there may be a device malfunction, and you should contact the manufacturer.
J
James SmithAug 27, 2025
What to do if device error screen showed up on SpiroHome?
- C
  chadphelpsAug 27, 2025
  If a device error screen appears on your SpiroHome, it could be due to a few reasons. Ensure the Spiroway mouthpiece is installed correctly by referring to the user manual. Check the Spiroway to ensure that the lumen is not obstructed by any foreign object. Also, the Spiroway mouthpiece may be dirty or damaged, in which case you should replace it.
J
Jared CastilloAug 30, 2025
What to do if SpiroHome Clinic Measuring Instruments test does not start and animated balloon is not moving?
- S
  Sandra DavisAug 30, 2025
  If your SpiroHome Measuring Instruments test isn't starting and the animated balloon isn't moving, try the following: * Quit the test and start a new one. * Quit the application and start a new test. * Switch the device off and on again to reset it.
U
ucruzSep 2, 2025
Why SpiroHome Clinic Measuring Instruments test starts before blowing?
- M
  Mary HartSep 2, 2025
  If your SpiroHome Measuring Instruments test starts before you begin blowing, it's likely due to vigorous handling of the device. Ensure you keep the device as stable as possible after starting a test.
J
John TravisSep 5, 2025
What to do if SpiroHome Measuring Instruments disconnected during test?
- F
  Fernando BentonSep 5, 2025
  If your SpiroHome Measuring Instruments disconnects during a test, it could be because the device was accidentally turned off or due to rough handling. In this case, switch the device on again and proceed with a new test. It may also be caused by a dropped BLE connection. Reconnect the device and start a new test.
Q
qweeksSep 8, 2025
Why SpiroHome Clinic Measuring Instruments test quality grade always low?
- S
  Sherry NelsonSep 8, 2025
  If your SpiroHome Measuring Instruments consistently shows a low test quality grade, it indicates that the test is not being performed correctly. You should repeat the test, carefully following the rules and conditions specified in the 'Performing a Lung Function Test' section of the user manual.
S
Sara ArmstrongSep 12, 2025
What to do if SpiroHome Clinic Measuring Instruments device is not responding to button?
- J
  John YoungSep 12, 2025
  If your SpiroHome Measuring Instruments device isn't responding to the button, it may be due to a device error. Remove the batteries, wait 30 seconds, and then reinstall them to resolve this issue.

Summary

INTRODUCTION

PRODUCT DESCRIPTION

Describes the SpiroHome Clinic as a portable spirometer and its basic functionality.

WHATS IN THE BOX

Lists the components included in the SpiroHome Clinic package.

INTENDED USE

Specifies who the SpiroHome Clinic is intended for and its purpose.

RESTRICTIONS ON USE AND CONTRAINDICATIONS

Details limitations, contraindications, and precautions for using the spirometer.

PARAMETERS

Lists and defines the spirometry data parameters measured by the SpiroHome Clinic.

OPERATION

OPERATING ENVIRONMENT

Specifies the required temperature, humidity, and pressure for device operation.

SETTING UP YOUR DEVICE

Step-by-step guide for installing the app, creating an account, and pairing the device.

DEVICE INDICATORS

Explains the meaning of the LED lights on the device for status indication.

PERFORMING A LUNG FUNCTION TEST

Details the general procedure, breathing maneuvers, and test completion.

UNDERSTANDING THE TEST QUALITY

Explains how test quality is graded and the criteria used for acceptability.

SIGNS AND SYMBOLS

Identifies and explains important markings and symbols used in the manual.

TECHNICAL FEATURES

Details the technical specifications and measurement capabilities of the device.

SAFETY WARNINGS AND PRECAUTIONS

Provides critical safety information, warnings, and user precautions for device use.

MAINTENANCE

CALIBRATION-CHECK

Instructions for checking the device's calibration using a syringe.

CLEANING AND DISINFECTION

Procedures for cleaning and disinfecting the SpiroHome Clinic device.

THE SPIROWAY DISPOSABLE

Information regarding the single-use SpiroWay mouthpiece and cross-contamination risks.

BATTERIES

Details battery type, life, replacement instructions, and low battery indication.

DISPOSAL OF SpiroHome

Guidelines for the proper disposal of the device and its batteries.

TROUBLESHOOTING

TERMS OF WARRANTY

ELECTROMAGNETIC COMPATIBILITY

MANUFACTURER INFORMATION

SpiroHome Clinic Specifications

General

Device Type	Spirometer
Measurement Method	Ultrasonic
Connectivity	Bluetooth
Power	Rechargeable battery
FEV1	Yes
FVC	Yes
PEF	Yes
Compatibility	iOS, Android
Measured Parameters	FEV1, FVC, PEF
Flow range	0-16 L/s
Volume range	0 to 10 L
Weight	150 grams