6
Technical Information
Characteristics
Noise
Vibration
Declaration
of conformity
Tool fixing ……………………………………… triple-grooved profile
Voltage ……………………………………………………………230 V
Frequency ………………………………………………… 50 - 60 Hz
Amperage …………………………………………………………3.5 A
Power input ……………………………………………………710 W
Hammer rate ……………………………………………0 - 3500 min
-1
Hammer impact ………………………………………………0 - 3.7 J
Weight …………………………………………………………… 4.3 m
Cable length ……………………………………………………… 4 m
Carbons …………………………………………… self-disconnecting
Lubrication ………………………………………… grease lubrication
Angle of chisel………………………………………………3 positions
Switch ………………………………………… with electronic control
Class II………………………………………………………………
Measured values determined according to 84/537/EEC. Typically the
A-weighted noise levels of the tool are:
Sound pressure level: 78,9 dB(A)
Sound intensity level: 97,9 dB(A)
Wear ear protection!
The typical weighted acceleration is 5,7 m/s
2
.
We declare under our sole responsibility that this product is in con-
formity with the following standards or standardized documents:
EN 50144, EN 55014, EN 61000, HD 400, in accordance with the
regulations 73/23/EEC, 89/336/EEC, 98/37/EC
Didier BOURRETTE Jens STELLWAG
SPIT S.A., Route de Lyon - B.P. 104, F-26501 Bourg-les-Valence
To Next Page
Loading...