Spitfire DC40 - Electricity Supply Requirements; Fuel Supply Guidelines

5


ELECTRICITYSUPPLY
The SPITFIRE range of heaters is designed to run off 220‐240V Single‐Phase 50Hz electrical
supply.Theunitshouldbepluggedintoa10Aoutlet.
WARNING:Thisappliancemustbeearthed.
Note:IfthePlugneedstobereplacedtosuitlocalrequirementsaqualifiedelectricianshould
carry out the
 replacement taking care to earth the unit and maintain the correct phase
connectionasperthewiringdiagram.


FUELSUPPLY
Pleaseonlyusethefollowingfueltypesintheheater: Kerosenewithviscosityof1.3 cstor
Dieselwithviscosityof1.5cst.
WARNING: Undernocircumstancesshouldanyotherfueltypebeused. Donotfillthefuel
tankwhiletheheaterisrunning.

