Troubleshooting
Problem:
Its taking a long time to dry.
Possible causes / Solution:
Before you call our Customer Care Department, go through the following troubleshooting suggestions:
Spare Parts
This dryer is a complex machine. Repairing it yourself or having a non-authorized person try to repair it could
cause harm to one or more persons and to the machine, and could invalidate the spare parts warranty.
If you still have a problem call our Customer Care Department on: 1 800 356 0766
Electrical Shock Hazard
Plug into a grounded 3 prong outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can result in
death, fire, or electrical shock.
WARNING
The dryer won’t start.
• The filter has not been cleaned (see Maintenance).
• The temperature setting is not ideal for the type of fabric you are drying (see
Start and Programs, and see Laundry).
• Automatic / Sensor Dry programs require a HIGH temperature setting (see Start
and Programs).
• The correct program has not been selected for this load (see Start and
Programs, and see Laundry).
• The exhaust duct is obstructed (see Installation).
• The air intake vent is obstructed (see Installation).
• The permanent ventilation flap on the storm cover is obstructed (see Installation).
• The items were too wet (see Laundry).
• The dryer was overloaded (see Laundry).
• The plug is not plugged into the socket, or not making contact.
• There has been a power outage.
• The fuse has blown.
• The door is not closed securely?
• The PROGRAMS knob has not been set properly (see Start and Programs).
• The START button has not been pressed (see Start and Programs).
EN
10
• Room temperatures below 45°F (7°C) may cause the dryer not to shut off at the
end of the automatic sensor cycle.
The dryer won’t shut off.
To Next Page
Loading...
