To Next PageTo Next Page
Need help?Do you have a question about the S+S Regeltechnik THERMASGARD RTM1 and is the answer not in the manual?
General| Enclosure protection class | IP65 |
|---|---|
| Protection class | II |
| Mounting | Wall mounting |
| Sensor | PT1000 |
| Type | Room thermostat |
| Temperature range | -35...+35°C |
Specifies the power supply requirements for the device.
Details the power draw of the device under different conditions.
Describes the integrated temperature and humidity sensor capabilities.
Outlines the operational temperature measurement limits.
Specifies the accuracy tolerance for temperature measurements.
Describes how and where the device can be mounted.
Explains how to set the Modbus bus address using DIP switches.
Explains how to set Modbus bus parameters like baud rate.
Details how to adjust the temperature offset using potentiometers.
Explains how to set the Modbus device address using binary coded DIP switches.
Details the configuration of baud rate, parity, and bus termination.
Explains the meaning of the device's LEDs for communication status.
Mentions the integrated error diagnostic function.
Details how to control individual segments of the display using registers.
Explains how to program the 14-segment display areas with characters.
Provides the ASCII mapping for characters displayed on the dot matrix area.
Details Modbus registers for configuring device parameters and display.
Lists Modbus registers for reading temperature, dew point, and humidity values.
Explains sub-functions for device diagnostics and error reporting.
Details the telegram structure for reporting the slave device identity and version.
Illustrates common Modbus RTU network configurations and topologies.
Explains the electrical setup of the Modbus bus with resistors.
Details the rules for installing terminating and bias resistors on the Modbus bus.
Offers important considerations for physical mounting and environmental factors.
Covers general terms, safety, intended use, and warranty disclaimers.
