Improper operation, lubrication, maintenance or repair of this product can be
dangerous and could result in injury or death.
Do not operate or perform any lubrication, maintenance or repair on this product, until
you have read and understood the operation, lubrication and maintenance or repair
information.
Safety precautions and warnings are provided in this manual and on the product. If these
hazard warnings are not heeded, bodily injury or death could occur to you or to other
persons.
The hazards are identified by the “Safety Alert Symbol” and followed by a “Signal Word”
such as “Danger”, “Warning “or “Caution”. The safety Alert “Warning” label is shown below.
Warning
The meaning of this safety alert symbol is as follows:
Attention! Become Alert! Your safety is involved.
The message that appears under the warning explains the hazard and can be either written
or pictorially presented.
Operations that may cause product damage are identified by “NOTICE” labels on the
product and in this publication.
Spread-a-Bale cannot anticipate every possible circumstance that might involve a
potential hazard. The warnings in this publication and on the product are, therefore,
not all inclusive. If a tool, procedure, work method or operating technique that is not
specifically recommended by Spread-a-Bale is used, you must satisfy yourself that it
is safe for you and others. You should also ensure that the product will not be
damaged or made unsafe by the operations, lubrication, and maintenance or repair
procedure that you choose.
The information, specifications and illustrations in this publication are on the basis of
information that was available at the time that the publication was written. The specification,
torques, pressures, measurements, adjustments, illustrations and other items can change at
any time. These changes can affect the service that is given to the product. Obtain the
complete and most current information before you start any job. Spread-a-Bale dealers have
the most current information available.
EC Declaration of Conformity
In accordance with ED Directive 2006/42/EC
1. We, Spread-a-Bale Ltd declare under our responsibility that the product
2. Machine Name: SPREAD-A-BALE
3. Machine Type: M Series, Mini, Mini RB1.8, Midi & Maxi
To Next Page
Loading...