TDS RO 30
TDS DI 1
Press enter to display current TDS values
after the RO and after the DI.
Press enter again to display:
Total water used since last pre-filter change
and zeroing of counter.
Overall amount of water used since install.
Total 12.3kl
Overall 200.5kl
Pressure 44psi
Temperature 18c
Press enter again to display:
Pressure of mains water in PSI.
Temperature of water to hose (degrees C)
WARNING
Water Discnnectd
This message during a fill suggests that the
mains water has been disconnected.
WARNING
Pressure Error
This message indicates that the pressure
sensor has been disconnected or has
failed.
The pressure has dropped below the value
set in Pressure Threshold, indicating a
blocked carbon or sediment filter.
WARNING
Carbon Filter
WARNING
Chk RO Membrane
This message is displayed when the amount of
water that has flowed goes over the Total Flow
Threshold. Check the RO membrane.
TDS RO 30
TDS DI 1
Press enter again to return to TDS values.
The S3 has a number of warning messages for when something goes wrong in the
system, these are designed to help with trouble shotting.
F
Start / Stop Filling Increase a value
or go up to next
menu item
Decrease a value
or go down to
next menu item
Enter / Set a
value or scroll to
next display item
Operation
S3
Warning Messages
S3
Flow 2.4l/m
Press enter again to display:
Flow in litres per minute.
This message is displayed when the
system is flushing.
System
Fill- Autoflush
System
Ignoring TDS
This message is displayed when the system is
flushing and shortly after the system has
completed flushing.
This message is displayed when the
system is full.
System
Full
System
Filling
This message is displayed when the system is
filling.
This message is displayed when the system
is paused by the TDS exceeding the limit
and the TDS Shutdown is ‘On’.
System
Filling paused
WARNING
High RO TDS
This message is displayed when the the TDS
exceeds the set limit.
WARNING
High DI TDS
To Previous Page
Loading...
Need help?
General