16
• Uncoil the power cable comple-
tely before use.
• Disconnect the mains plug as
soon as you have finished using
the appliance. Do not pull the
power cable itself, as it could
cause damage.
• Switch off the machine before
plugging in or unplugging it.
• The appliance must not be ope-
rated with an external timer or a
separate remote control system.
• Always disconnect the mains plug
after use, before cleaning, or in
the event of possible malfunc-
tions during operation.
• Do not submerge the appliance
in water or any other liquid. Pro-
tect the power cable and plug
from moisture.
• The appliance and its accessories
are not dishwasher-safe. Only
the containers may be cleaned in
the dishwasher.
• Never place or use the appliance
and power cable on or near a hot
surface.
• The cable must not hang over the
edge of the work surface.
• Do not use the appliance
outdoors.
• Do not put objects or your hand
in the appliance while it is in
operation.
NOTICE: PROTECTION
FROM OVERHEATING
• Your Sam Hand Blender provides
protection from overheating.
• Overheat protection monitors
the engine temperature. It might
switch off the engine automati-
cally. In this case, turn off the
power properly and unplug the
power cord.
• Your hand blender will only be
ready for use again once the en-
gine has cooled down.
BEFORE USING THE APPLI
ANCE FOR THE FIRST TIME
• Remove all parts related to
packaging and transport safety.
Make sure that these parts are
also kept away from children –
they pose a risk of suffocation!
• Before initial operation and af-
ter prolonged periods of non-use,
Sam should be cleaned. When
doing so, please make sure to
note our instructions on cleaning
and care.
• Place the appliance on a level and
dry surface.
To Next Page
Loading...