Installing the Tank – Part 1
16) Connect a water connector
to the PVC nipple coming out
from the shut off valve.
Note: All connections will
require plumbers' tape to avoid
leaks.
13) Install the shut off valve
onto the incoming water supply
on the pre-plum.
14) Apply plumbers' tape to the
threads on the PVC nipple then
thread it into the other end of the
shut off valve. Fully tighten it.
15) Position the well water tank
next to incoming pre-plumb
with its connections facing back
Well Water
Filter Tank
This step will require the materials listed below
Plumbers Tape
Wrench
1-inch (24-inch Long) Corrugated
Water Connectors (x1)
12) Turn off the water to the
home and prep the pre-plumb.
You will attach a 1-inch threaded
adapter to each connection.
Questions? Call (800)-589-5592 6
17) Connected the corrugated
pipe to the incoming side on
the back of the well water
filter. Ensure it is fully
tightened.
1-inch (3-inch long) PVC
Nipple
1-Inch PVC
Shut Off Valve
Well Water Filter System
To Next Page
Loading...
Need help?
General
