Spromise S378 - Menu Settings; Trigger Timing and Workday; System Menu Settings

7
Trigger
Start-Stop
1/2
The camera can be set to operate only at
specific time period. To enable this function
select ON and press ok. The start-stop
menu will then appear. This menu contains
the settings for times to start and stop as
well as the trigger interval and time lapse
interval. The start-stop setting will override
all other general camera settings. Since
there are 2 periods available, make sure to
not program times that overlap.
Work Day
Enable or disable the PIR trigger and Time
lapse trigger by day of the week.
System
Set Clock
Must choose right timezone and Save.
Camera ID
Watermark in the left bottom corner, up to 5
digits.
GPS
coordinate
Could be written to exif info of photo.
Time Stamp
ON /Off. Choose if the image stamp is to be
shown or not.
Overwrite
Cycle writing the SD card.
Beep
Enable or disable key tone
LED indicator
Enable or disable blinking of indicator.
FW Update
Start to update FW and MCU once update
files copied to SD card root directory.