© 2021 SPT Labtech Ltd
There are two ways to run the loop: Outer Loop and Inner Loop.
Outer Loop: user can edit the Loop Cycle and select “Run Loop” from the main menu
to run all the protocol lines in loop. During protocol running, the Loop Cycle number
will be decreasing simultaneously until Protocol
nished.
Inner Loop: user can select the function “Start Loop” to edit the Loop Name and Loop
Cycle. The protocol lines between Start Loop and End Loop will be r
unning in a loop.
Start Loop and End Loop can be adjusted by moving up and down between the
protocol lines. During protocol running, the remaining loop number is shown in the
status bar located in the bottom.
To Next Page
Loading...