EasyManua.ls Logo

SPT SH-1506 - Operating the Heater and Humidifier; Using the Heater Function; Using the Humidifier Function

SPT SH-1506
7 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
machine. If this happens, immediately switch off unit, disconnect the plug
and call a qualified service engineer.
Never remove any covers.
Please turn the unit off and unplug before moving.
WARNING: In order to avoid overheating, do not cover the
heater.
The heater must not be located immediately below a socket
outlet.
Care should be taken when using the appliance due to the
emission of hot water vapor.
Unplug the appliance during water filling and cleaning.
OPERATION
The heater / humidifier will work most effectively in an average-, or medium-
sized room.
HEATER ONLY
Plug the power cable into a suitable power socket.
Adjust the heating control knob to the desired setting: LOW or HIGH heat.
(Turning to the right side of the dial)
Low: About 700W heat
High: About 1200W heat
Turn the control knob to the “OFF” position when not in use.
HEATER WITH HUMIDIFIER
Before adding water, first turn OFF the unit at the control knob and unplug
from power source.
IMPORTANT NOTE: If the humidifier has just been used, allow the unit to cool
before adding any more water, otherwise steam and/or hot water may be
ejected from the steam vent during filling.
4