At Home SPX Reformer Owner’s Manual6
Assembling the SPX Reformer
STOP! Read these instructions completely before beginning or refer to our online assembly video at: merrithew.com/eq-assembly
1. Insert gearbar [26] into middle gearbar slot [5] with the
caution sticker and concave indentations facing wooden
standingplatform [4].
2. Insert pulleybars [23] into receptacles [34] at rear of
Reformerand tighten star knobs at base of receptacles.
Ensureeyehooks on top of pulleybars are parallel to aluminum
rails [15] and that star knobs are fully tightened so there is no
movement of the pulleybars.
3. With two people, tilt Reformer onto one side.
As one person steadies Reformer, the second person inserts
free ends of ropes [22] through back of pulleys [25], then
through rope guide tubes [27] underneath carriage.
4. Tie a knot leaving a 6-8" tail to prevent ropes from passing
back through rope guide tubes.
5. Return Reformer to upright position. 6. Position shoulder rests directly over pre-drilled screw holes.
ASSEMBLY & SET-UP
To Next Page
Loading...