© 2013–2017 Schneider Electric All Rights Reserved
80043-808-02 Rev. 02 I-Line™ Combo Switchboards
03/2017 Introduction and Safety Precautions
7
ENGLISH
Introduction
This bulletin contains instructions for installing Square D™ brand
I-Line™ Combo switchboards. These switchboards are Underwriters
Laboratories (cULus) listed and accept I-Line, QO, QOB, ECB, EDB,
EGB, and EJB branch circuit breakers.
Safety Precautions
NOTE: For technical support on the installation of this I-Line Combo
switchboard, contact the Schneider Electric Customer Information Center
at 1-888-778-2733.
NOTE: See the labels on the equipment for rating and safety information.
Additional equipment labels are provided with this document.
HAZARD OF ELECTRIC SHOCK, EXPLOSION, OR ARC FLASH
• Apply appropriate personal protective equipment (PPE) and follow safe electrical work
practices. See NFPA70E, CSA Z462 or NOM-029-STPS.
• This equipment must only be installed and serviced by qualified electrical personnel.
• Turn off all power supplying this equipment before working on or inside the equipment.
• Always use a properly rated voltage sensing device to confirm all power is off.
• Read and understand this entire instruction bulletin and the latest edition of the NEMA PB
1.1 standards publication included before installing, operating, or maintaining this
equipment.
• Local codes vary, but are adopted and enforced to promote safe electrical installations. A
permit may be needed to do electrical work, and some codes may require an inspection of
the electrical work.
• Replace all devices, doors, and covers before turning on power to this equipment.
Failure to follow these instructions will result in death or serious injury.
80043-808-01.book Page 7 Wednesday, March 22, 2017 12:31 PM