EasyManuals Logo

Square D I-Line User Manual

Default Icon
188 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #8 background imageLoading...
Page #8 background image
© 2013–2017 Schneider Electric All Rights Reserved
I-Line™ Combo Switchboards 80043-808-02 Rev. 02
Installation—Interior Mounting into Square D Brand Enclosures 03/2017
8
ENGLISH
Installation
This section provides instructions for the following I-Line Combo
switchboard procedures.
Interior Mounting into Square D Brand Enclosures, on page 8
I-Line Combo Circuit Breaker Installation and Removal, on page 10
ECB, EDB, EGB, and EJB Circuit Breaker Installation and Removal,
on page 15
QO and QOB Circuit Breaker Installation and Removal, on page 17
Circuit Breaker Reset Instructions, on page 20
I-Line Interior Trim Barrier Preparation, on page 20
Interior Mounting into Square D Brand Enclosures
A separate standards publication, titled “General Instructions for Proper
Installation, Operation, and Maintenance of Panelboards Rated 600 Volts
or Less” (NEMA PB1.1), has been provided with this equipment.
Familiarize yourself with the content of this document before proceeding
with any of the following procedures.
If you did not receive a copy of this document, or if you have any
questions regarding this equipment, contact your local distributor or
Schneider Electric representative.
To properly mount and install the I-Line Combo switchboards enclosure,
please refer to the NEMA PB 1.1 standards publication, and follow the
instructions for either Surface Mounting (Enclosure Mounted on Wall),
on page 8, or Flush Mounting (Enclosure Recessed in Wall), on page 9.
Surface Mounting (Enclosure Mounted on Wall)
1. Mount the enclosure as instructed in the NEMA PB 1.1
standards publication.
2. Install one elevating nut on each enclosure stud.
NOTIC
E
HAZARD OF EXCESSIVE HEAT DUE TO LOOSE CONNECTIONS
Ensure all connections are properly tightened.
Refer to the torque information label provided on the I-Line Combo
switchboard before tightening the connections.
Failure to follow these instructions can result in
equipment damage.
80043-808-01.book Page 8 Wednesday, March 22, 2017 12:31 PM

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Square D I-Line and is the answer not in the manual?

Square D I-Line Specifications

General IconGeneral
Bus MaterialAluminum or Copper
Voltage Rating600V AC
Current RatingUp to 1200A
EnclosureNEMA 1
Poles2, 3
Interrupting Rating200 kA (depending on the specific model and installed breakers)